Effects Loops - Rane TTM56 Operator's Manual

Rear Panel Hook-up
N108
CLASS 2
EQUIPMENT
POWER
750mA
Inputs
PGM 1 and PGM 2 each have stereo PHONO and stereo LINE inputs.
PHONO 1 and PHONO 2 inputs are RIAA compensated inputs, for turntables only!
PHONO GND terminals provide independent ground connect points for turntables. It is very important that each turntable have
a very good ground connection to one of these terminals. The thumbscrews will come off if they are over-rotated, so be
careful not to spin them off and lose them.
LINE 1 and LINE 2 inputs are unbalanced line-level inputs with a sensitivity of -10 dBV (max gain).
AUX INPUT may be used with a drum machine, groovebox, sampler, or another mixer's output for session mix. This Input is
mixed after the Crossfader and Effects loop.
MIC INPUT is a balanced input specifically designed for a dynamic microphone.
Power
POWER connector. This is not a telephone jack! Connect only the Rane RS 1 power supply included with your TTM 56.
The POWER switch is located just above the power connector. You know what to do with this one, but leave it off until every-
thing is connected.

Effects Loops

MIC EFFECTS insert jack is unbalanced. It is wired for TRS, Tip=Send, Ring=Return. This is an independent Effects Loop for
the Mic. There is no engage switch, so the Mic signal is always processed when you have an effects box connected. If you
are connecting to an effects processor with a Send/Return jack, a single TRS cable will work. If your effects processor has
separate Send and Receive jacks, you need a "Y" cable. You can buy a Send/Return cable from your local music store, or you
can make one of your own, as shown below.
FlexFX EFFECTS jacks are unbalanced mono ¼" TS (Tip/Sleeve). This stereo loop is used for output to (send) and input from
(return) an effects processor. The SEND jacks provide the output to your effects processor. The RETURN jacks provide input
for the signal returning from your effects processor. To use with effects insert devices with a single TRS, tip=send,
ring=return jack, you need a "Y" cable, as shown below.
T = SEND
R = RETURN
S = SHIELD
Manual-2
TTM 56
MADE IN U.S.A.
RANE CORP.
U.S. PATENT
PENDING
MASTER OUT
AUX
OUT
L L
R R
BALANCED
RED
1-CONDUCTOR SHIELDED CABLE
RED
1-CONDUCTOR SHIELDED CABLE
SHIELD
Send/Return Cable Wiring
FlexFX
RETURN SEND
L
IN LINE 2
R
UNBALANCED
SHIELD
SHIELD
PHONO GND
PGM 2 PGM 1
PHONO 2 LINE 1 PHONO 1
L L
R R
RED
RED
RETURN
MIC
BAL INPUT
EFFECTS
TIP = SEND
RING = RTRN
SEND