Table of Contents
Advertisement
4.1 Installation of batteries
Remove the cover of the battery compartment on the rear panel of the remote control unit;
slide it downwards and put it aside. Insert two AAA (R03) batteries into the compartment,
observing the indicated polarity. Do not mix old and new batteries, or batteries of
different types. Replace the battery compartment cover. Slide it upwards until it locks in place.
5. Front panel
USB:
Port for connecting an external USB memory device.
POWER:
Press power key one time to power off the receiver. Press again to reboot the
receiver. To switch the receiver to standby is only possible with the standby key
on the remote control.
:
Switches to the next/previous channel, moves the cursor up/down in the Menu.
CA:
Socket for a subscriber's card – always insert with the chip facing up!
CI:
Socket for the CAM conditional access modem.
10
Advertisement
Table of Contents
Need help?
Do you have a question about the ARIVA @Link 200 and is the answer not in the manual?
Questions and answers