Table of Contents
Advertisement
8 | N ordC2ComboorgaNUsermaNUalosv1.X
4
Getting Started
Let's take a few minutes to get familiar with the Nord C2 . The user interface is designed to be as intuitive as possible, and to perform as well as you do
in a live situation . We hope that you soon will feel confident using it, and by following this short chapter, we will go through most of the functions .
About the programs
Complete sound settings are stored in the Program memory of the
Nord C2 . This memory area has 126 locations . Every program can be
edited and replaced as you wish . A complete set of the factory pro-
grams are available on the www .nordkeyboards .com website .
Select a program
Press the Up or Down button repeatedly until you've selected the
desired program number . The program will be loaded immediately .
Edit a program
Editing a program is just as easy as grabbing a knob, press some
drawbar buttons to change a setting, or press a button to select a
different setting . The knob's physical position isn't always as the stored
setting in the program that is active, but as soon as you start turning a
knob, the parameter will snap to the knob's position .
When you have edited a program, a dot will appear in the lower right
display corner next to the program number . This will alert you to the
fact that the program has been edited but not yet saved . If you select a
new program without saving, any edits you have made will be lost and
the program will have its original settings the next time you select it .
Memory protect
There is a Memory Protect function that is set to On when the Nord C2
leaves the Nord Factory . This has to be turned Off in the System Menu
before you can save a program .
1
Press
Shift + System and use the Up/Down buttons to select
the Memory Protect Option – this is the very first option in the
System menu .
2
Change the setting of the memory protection to Off by pressing
and holding Shift and the Up or Down buttons .
3
Exit the System menu by pressing the Prog / System button again .
M
The setting of the memory protection will be remembered even if
the Nord C2 is turned off.
Storing a program
If you are happy with an edit that you have made,
you should probably Store the program .
1
Press the
Store button .
The program number LEDs starts flashing.
2
Select a new location where you want to store the program .
Use the Up/Down buttons to navigate to a new program location
if you do not want to overwrite the original program.
3
Press the
Store button a second time to confirm your choice .
The edited program has now replaced the previous one in the
location you specified.
M
To cancel the procedure, press the Shift button before you press
Store the second time.
M
With Memory Protect set to Off, a double tap on the Store button
will store a Program in its original location.
Advertisement
Table of Contents
