Table of Contents
Advertisement
Bass Pedal
To play the Nord C2 Combo Organ's dedicated bass registers, connect
the MIDI Out from your external controller (preferably a bass pedal-
board) to the Bass Pedal connector . The bass registers will respond to
all MIDI note messages received regardless of their MIDI channel .
Audio connections
Monitor In
Use this to connect and monitor a signal from an mp3 or a CD player
at the Nord C2's headphone output . This allows you to e .g . rehearse
with the C2 to pre-recorded music .
M
Signals connected to this input will not be processed with the
Nord C2's effects or appear at the left and right output jacks.
Main stereo output - Left & Right
The left and right line level outputs from the Nord C2 are unbalanced .
Use the ¼" connectors to connect the Nord C2 to an amplifier or
recording equipment .
General guide on audio connections:
• Make all the connections before you turn on the power to your amplifier.
• Turn on the power to your amplifier last.
• Turn off the power to your amplifier first.
Headphone output
This is where you connect a ¼" stereo connector from a pair of head-
phones .
E
Playing at a high volume level can result in hearing impairments
such as permanent hearing loss.
Rotary Speaker
The rotary speaker high level outputs consist of a ¼" and a 11-pin
Leslie™ standard connector . The high level out are 14V RMS high level,
unbalanced, and are only intended to be used, directly connected to
a rotary speaker cabinet with built in amplifier . Any other form of use
might result in damaged equipment .
It is possible to route the tonewheel organ to the High Level and 11-pin
outputs and the other organs to the main outputs . Other combinations
are also possible . Read more about this on page 17 .
3CoNNeCtioNs
| 7
Advertisement
Table of Contents
