ii.
Use the two Thumb screws to tighten the second battery.
iii.
Push Menu button that will show the Main/ Second Battery Status.
**NOTE
When the Hot-Swap battery low,
battery power, and swap other Hot-swap battery.
battery pack status in lower than 20% you will see the warning red light blinking in
LED.(See detail at Chapter 1.3). You can hold "F3" button for 4sec to turn the
Windows System into S3 (sleep) mode.
Users Manual
Rugged Computing
PUSH F3L
to change battery back to Main
40
Step1. When the main
Rugged Table PCs