Table of Contents
Advertisement
... continued
... continued
... continued
Problem
What to do
Error message
Boot your PC and when you see the message "Press
"Signal frequency
<INS>
is out of range"
Display properties and change resolution to a
supported mode, see Display modes table in Technical
fact sheet.
Colour defects
Make sure that the display unit is at least 30 cm from
other electrical equipment.
Check that the signal cable connector is properly
connected and that the connection pins are not bent or
damaged.
Try another colour temperature, see section Adjusting
the picture.
Size, position,
Adjust the picture characteristics as described in section
shape and quality
Adjusting the picture.
y
unsatisfactor
Objects on the
Change resolution or font size, see EasyGuide, your
screen either too
computer's online help.
small or too large
Screen flickers
If the screen display shows a grid pattern, the screen
may look as if it is flickering slightly. This is normal.
Also see list of recommended display modes in section
Technical fact sheet.
Characters on the
Adjust Focus as described in section Adjusting the
screen seem to
picture.
flicker
Characters on the
First adjust Horiz. Size until the characters are uniform,
screen in DOS
the fine-tune them using the Focus adjustment, see
mode not uniform
section Adjusting the picture.
Project Fujitsu x150f Display Unit print original
Writer Marita Näsman-Repo
Date
March 2, 1998
for SETUP mode", press
English
16
. Then go to
F8
Continued...
Advertisement
Table of Contents
