Yaesu FT-8900R Operating Manual page 12

button: default setting is TONE function
Press this button repeatedly to select the
ENC → ENC.DEC (Tone Squelch) → DCS
button: default setting is LOW function
Press this button repeatedly to select the transmitter power output level on the
band:
LOW : 5 watts VHF/UHF
MID2
MID1
HIGH
When the
Main
this key for ½ second to switch the memory channel display between the Frequency
format and Alpha-numeric Tag format.
(4) LAMP Switch
This switch illuminates the Microphone keypad.
(5) LOCK Switch
This switch locks out the Microphone buttons (except for the keypad and PTT switch).
(6) / buttons
Press (or hold in) either of these buttons to tune (or scan up or down) the operating frequency
or through the memory channels on the
function of the (rotary)
Yaesu FT-8900R Operating Manual Expanded Edition (courtesy of W5JCK)
: 10 watts VHF/UHF
: 20 watts VHF/UHF
: 50 watts VHF, 35 watts UHF
band is set to the
Memory
Main
knob.
DIAL
or mode on the
CTCSS DCS
mode or
Home Channel
band. In many ways, these buttons emulate the
INTRODUCTION
band:
Main
Main
, press and hold in
Page 12 of 77