Casio VZ-8M Operation Manual page 71

SAVE/LOAD = SAVE/LOAD
CARD/MIDI = CARD I/CARD 2/MIDI
DATA = VOICE/OPMEM/VC + OP/FULL
63 SflUE/LOflD
SflUE/LOflD=SRUE
'II
QZ SflUE
PUSH YES KEY!
This function is essentially a "utility" function, which is
used to control data SAVE and LOAD operations.
The SAVE/LOAD parameter is used to specify the type
of operation you want to perform. When SAVE is select
ed, the onboard memory data will be "saved" to an exter
nal memory medium, while when LOAD is selected,
external data will be "loaded" into the onboard memory.
The CARD I/CARD 2/MIDI parameter lets you choose
the medium to/from which you will SAVE or LOAD data.
When CARD is selected, data will either be saved to, or
loaded from a RAM/ROM card inserted in the card slot.
If you want to SAVE the data, be sure to also set the
CARD parameter to "CARD 1". When MIDI is selected,
data will be transferred to or from another VZ series syn
thesizer.
When using a new RAM card, you must first format it (see
TOTAL-06).
The DATA parameter lets you choose the type or combi
nation of data which will be saved or loaded. You can
choose from three different settings — VOICE, OP MEM
or VC+OP. Note, however, that when using two VZ units
connected by MIDI, this setting must be the same for both
units (except when executing SAVE or LOAD).
When "VOICE" is selected, all 64 internal sounds can be
transferred to or from the internal memory. When "OP
MEM" is selected, only data from the 64 operation
memories can be transferred to or from the unit.
•71
SAVE/LOAD
Parameters
93 SflUE
CflRD/MIDI=CflRDl
A
PROTECT ON—
TOTflL CONT 02!
A
O/S EDIT—PAGE—CURSOR—VALUE
Domain
Combination
Mode Normal
4 mix/split
K
GLOBAL
W
03 SflUE
I=FULL
—MIDI DISflBLE™
* TOTflL CONT 05!
When "VC + OP" is selected, data from both the 64 in
ternal sounds and the 64 operation memories can be trans
ferred.
When "FULL" is selected, data from the "VC + OP"
parameter and TOTAL CONTROL menu functions 00,
01, 04 and 05 can be transferred to or from the unit.
Once you've specified the operation you want to perform,
press the YES key. Respond to the menu prompt by press
ing the YES key once again.
If you want to abort data transmission, simply press the
cursor or NO (VALUE ▼) key of the transmitting or
receiving device.
Note that when an Operation Memory featuring INTER
NAL sounds is SA VED to a card, the sound specification
on the display automatically changes to "CARD" for the
formerly INTERNAL sounds.
Note that if the memory protect is set to ON (TOTAL-02),
it will be impossible to LOAD data. (FIG-F)
Note that if MIDI Exclusive is disabled (TOTAL-04) or
basic channels do not match, MIDISA VE/LOAD will be
impossible.
If data is not transferred successfully for some reason,
MIDI SA VE/LOAD will be impossible and display ap-
pears as in FIG-H.
If an ERROR message appears, operations can be reset by
pressing the MODE, PAGE or CURSOR keys.
Related Functions
Operation
8 mix
memory
03
EXECUTE? (YES)
--TRRNS ERROR—
CHECK SYSTEM!
8M