Initializing The Vz-8M; Initialized Data - Casio VZ-8M Operation Manual

Initializing the VZ-8M.

} VZ-8M can be "initialized" in a number of ways, allowing you to
t the entire unit to its initial factory settings or initialize only the data
/sic
fa specific MODE or FUNCTION, for example. The following describes
s various initializing procedures.
ALL INITIALIZE
) initialize all internal operation memory, voice and effect data to fac-
r preset values, hold down the WRITE key and turn the unit power
tf. All internal data is reset to its original state as listed on page 93.
SING VOICE menu FUNCTIONS
) initialize all parameters in any single VOICE menu function for a select-
i MODULE, simply press the EDIT key and the PAGE DOWN key and
fuse the PAGE keys to select the desired function. Then hold down the
fWRITE (COPY/INITIALIZE) key and respond to the prompt by press-
ling the YES key.
|The values of all parameters in the selected function are then reset to their
finitialized state (see page 94). Parameter values in other functions,
^however, remain unaffected.
W01CE-00 LINE (MIM2-M7M8)
[When this parameter is initialized, LINE DA TA of all modules (M1-M8)
gore initialized automatically.
yOICE-09 ENVELOPE (DCA)
\when this parameter is initialized, the data of not only VOICE-09 but
tAMP VEL RATE in VOICE-19 is automatically initialized.
VOICE-03 ENVELOPE (DCO)
When this parameter is initialized, the data of not only VOICE-03 but
iPITCH VEL RATE in VOICE-18 is automatically initialized.
^EFFECT MENU INITIALIZED DATA
| PRESET 1 operation memories H-6 throgh H-8 contain initialized data
] for the EFFECT MENU NORMAL mode, COMBI MODE and MULTI
ICH mode, respectively. (See page 96-98.)
r
OFFM —.ON
POWER
SYSTEM FILL
INITIRLIZE OK!
"i INITIRLIZE
PUSH YES KEY!
INITIRLIZE
OK!