Cabinet Installation - Thermador An American Icon PH30ZS Installation Instructions Manual

Ph series wall hood

Hide thumbs Also See for An American Icon PH30ZS:

Care and use manual (25 pages)

Service manual (16 pages)

Service manual (16 pages)

Table Of Contents

Table of Contents

Available languages

The hood can be installed under

a cabinet by supporting the

hood from the top.

Note: The cabinet must be

structurally joined to the wall

studs to support the weight

of this hood.

Figure 10 shows the four screw

holes (K) used for mounting the

hood to the bottom of the

cabinet.

Make sure both knockouts have

been removed.

1. In the base of the cabinet

drill 1/8" tap holes (See

dimension A in Figure 10

and in Table). Screw in four

#10 x 1" screws (provided

with hood) leaving 1/4"

exposed).

2. If the hood is installed for

vertical discharge, use

Figure 11 to create

clearance holes for passage

of the transition and conduit

(See dimension B in Figure

11 and in Table).

3. For horizontal discharge use

Figure 5 for the geometry of

the cutout required for

clearance of the transition.

4. Hang hood from screws and

tighten securely.

5. From inside of hood, insert

screws supplied. Drill

through holes (use #8 x 5/

8" screws supplied), one on

each side and four along the

front, into bottom of the

cabinet. See screws holes

labelled "L" in Figure 10.