Wall Mount Installation - Thermador An American Icon PH30ZS Installation Instructions Manual

Note: Read Remote Control Installation
Instructions before continuing if using this
accessory.

Wall Mount Installation

The hood installation height is the user's prefer-
ence. Figure 2 shows a typical installation of the
hood with two duct covers. Accessory 6" and/or 12"
duct covers are used to fill the space between the
hood and ceiling.
The installation height shown in Figure 2 is 36
inches. One 6" duct cover has been used in this
installation. Add or subtract duct covers as
appropriate to accommodate ceiling height and
desired hood height. The duct cover structure is
supported by the hood.
1. After the hood installation height has been
determined, draw a horizontal line at a distance
above the cooktop equal to the desired hood
installation height plus 15.5". This line is the
mounting location of the wooden bracket
shipped with the hood.
2. Find the centerline of the cooktop. Draw a
vertical line along this centerline up to the
horizontal line drawn in step 1.
3. The hood is mounted to the wall using a wooden
bracket shipped with the hood. Remove the
bracket from the hood by removing two shipping
screws. Mark the center line of the bracket.
4. Locate one stud on either side of the cooktop
centerline to use for mounting the wooden
bracket as shown in Figure 3.
5. Align the top of the wood bracket along the
horizontal line drawn in Step 1. Align the
centerlines of the bracket and cooktop.
6. Drill a 3" deep / " tap hole through the wooden
1
8
bracket, drywall, and into the stud.
7. Use 2 or 3 (#14 x 3") screws to attach the
bracket to the wall as shown in Figure 3. For
support of longer hoods, use three studs.
Countersink the heads to prevent interference
with the hood.
8. On the wood bracket mark the locations used to
hang the hood according to Figure 4 (next page).
9. Drill a 1 / " tap hole through the wooden bracket
8
and drywall. These (#8 x 5/8") screws do not
need to go into the studs.
10. Drill a 1/16" tap hole for the 2 (#8 x 5/8") screws
into the wood bracket leaving
exposed for hanging the hood.
Figure 2
Height
Above
Cooktop
Screws
(2 EA.
#14 x 3")
Figure 3
/ " of each screw
1
4
Page 5
24"
18"
Hood Height (36")
Standard
8 ft Ceiling
(96")
Standard
36" high
Range
Cooktop
Drywall
Centerline
6"
Duct Cover
Wall
Studs
Desired
Cooktop
Height
+ 15 1/2 "
To Cooktop
Surface