Important Safety Instructions - Thermador An American Icon PH30ZS Installation Instructions Manual

IMPORTANT SAFETY INSTRUCTIONS

SAFETY WARNING
Turn off power circuit at service panel and
lock out panel, before wiring this appliance.
REQUIREMENT: 120 V AC, 60 Hz. 20 A
CAUTION
FOR GENERAL VENTILATING USE
ONLY. DO NOT USE TO EXHAUST
HAZARDOUS OR EXPLOSIVE
MATERIALS OR VAPORS.
WARNING
TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE
FOLLOWING:
A. Use this unit only in the manner
intended by the manufacturer. If you
have questions, contact the
manufacturer. (Thermador Customer
Service at 800/735-4328.
B. Before servicing or cleaning the unit,
switch power off at service panel and
lock service panel. This will prevent
power from being switched on
accidentally. When the service panel
cannot be locked, securely fasten a
prominent warning device, such as a
tag, to the service panel.
CAUTION:
Vent Unit to the Outside.
C. Installation work and electrical wiring
must be done by qualified person(s) in
accordance with all applicable codes &
standards, including fire-rated
construction.
D. Sufficient make-up air is needed for
proper combustion and exhausting of
gases through the flue (chimney) of fuel
burning equipment to prevent back-
drafting. Follow the heating equipment
manufacturers guideline and safety
standards such as those published by
the National Fire Protection Association
(NFPA), the American Society for
Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE),
and the local code authorities.
E. Due to size and weight of this unit two
installers are recommended.
THE
F. When cutting or drilling into wall or
ceiling, do not damage electrical wiring
and other hidden utilities.
G. To properly exhaust air, be sure to duct
air outside. Do not vent exhaust air into
spaces within walls, ceilings, attics,
crawl spaces, or garages.
TO REDUCE THE RISK OF FIRE,
USE ONLY METAL DUCT WORK.
H. Install this hood in accordance with all
requirements specified.
Page 2
WARNING