Table of Contents
Advertisement
Installation
Preparation for installation
Before unpacking your fridge freezer, be aware of the following
points:
Find a suitable location for the fridge freezer; it should be
positioned as follows:
• In a dry room that can be ventilated.
• Out of direct sun light.
• Away from any heat source, e.g. stove or radiator (if this is
unavoidable, a suitable heat insulator should be used (not
supplied).
• A minimum gap of 25 mm from another fridge or freezer.
• A minimum gap of 10 mm above the fridge freezer.
• On a solid floor that will not sag under the weigh of the
fridge freezer.
Ensure that the fridge freezer can fit through all the doorways
on the route to its final location. The dimensions of the fridge
freezer with it handles installed are; 906 mm wide x 735 mm
deep x 1770 mm high.
If the fridge freezer will not pass through a door way:
Removing the freezer door
Remove the base panel(cover) first if it is attached.
1 Pull out bending tube guide and the left hand side water
tube.
2. Remove the retaining screws from the top hinge cover and
remove the hinge cover.
16
3 Turn top hinge fastener (turn in an anti-clockwise direction)
and disconnect the harness wires.
4 Lift up the hinge to remove. (As the hinge is removed
the door may drop down forward. Be careful.)
5 Be careful not to damage the water line when removing
the door.
Fridge freezer user guide
Hide quick links:
Advertisement
Table of Contents
