Advertisement
5. Plug the dispenser into the electrical socket. Press power ON/OFF
button. We are ready to complete the first cycle. In order to do that, wait
for the hot water to reach temperature (it will indicate ready with 3 beeps)
in approximately 10 minutes, and then wait for the cold to reach
temperature in other 40 minutes approximately (it will indicate ready
with 3 beeps).
6. Unplug the dispenser from the electrical outlet. Proceed to drain the
water from the faucets button, pressing hot water button and then cold
water button, until no more water remains. (to facilitate this operation,
use a large container)
7. Then, drain any water left in the tanks by opening the drain cap (stopper)
locates on the back side of the dispenser, until the left water drains
completely. Please do remember to close the drain cap(stopper) after
the drainage.
8. Then you could place a 5 gallon /3 gallon bottle of water onto the water
intake of the dispenser, allow water to stand for approximate one minute.
Or place a water purifier onto the water intake of the dispenser, then
pour tap water into the water purifier, also allow water to stand for
approximate one minute to let the water flow into tanks.
9. Push water faucet buttons to insure water flows from both faucets.
10. Plug the dispenser back to electrical socket.
11. Now you are ready to use your water dispenser.
ELECTRONIC
ELECTRONIC
CONTROL
CONTROL: : : :
CONTROL
ELECTRONIC
ELECTRONIC CONTROL
For storage/refrigerator cabinet
INS
INS
INS
INSTRUCTION
TRUCTION
TRUCTION
TRUCTION OF
OF
OF
OF LCD
LCD
LCD
LCD
For sterilization cabinet
Advertisement
