Advertisement
drain the rest water in the hot tank then tighten the cap. Open the cold
water faucet to drain the rest water in the cold tank.
� If you do not plan to use the water heating function for more than three
days, we strongly recommend that you turn off the hot water function.
TAKING
TAKING
DISPENSER
DISPENSER
TAKING DISPENSER
TAKING
DISPENSER OUT
� If the water dispenser will not be used for a long period of time, unplug the
power supply cord.
� Turn off the hot water.
� Drain the water through the faucets.
� Drain the water from tanks by drainage hole from the back of the
dispenser.
ATTENTIONS
ATTENTIONS
ATTENTIONS
ATTENTIONS
� Do not use the bottle with any crack, leakage or holes.
� Do not set "heating" function until water comes out of hot water faucet to
prevent any damage on the heating tube.
� Never set "heating" function when there is no water.
� In the process of using, check the water tray frequently. If the water tray is
full, please pour the water out in time.
� Do not change the set of "cooling" between "ON" and "OFF" in three
minutes and protect the compressor and extend the compressor usage
life.
� This water dispenser is not recommended for outdoor use. Locate the
dispenser vertically and on the flat floor. Please keep the back side of the
dispenser more than 20 cm to the wall or other appliance, to make a better
heating emanating for the condenser of the dispenser.
� Locate the dispenser away from direct sunlight and sources of heat (stove,
heater, radiator, etc.).
� Keep the body of the dispenser clean, avoid the body of dispenser to be
scratched by the hard and sharp things.
� Please do not incline the dispenser more than 45 degrees when move it.
And also when move the dispenser, to avoid dropping and crash.
� Please do not locate the dispenser near the costly appliance or facility, like
the TV, DVD.
PREPA
PREPA
RATION
RATION
BEFORE
BEFORE
PREPA
PREPARATION
RATION BEFORE
BEFORE FIRST
� Before connecting the appliance to the power source. Let it stand upright
for approximately 2 hours. This will reduce the possibility of a malfunction
in the cooling system from handling during transportation.
The water dispenser is pre-cleaned at the factory but the reservoir and water
lines must be flushed with fresh water before use as follows:
1. Keep the unit unplugged.
2. Check and make sure the backside hot water drainage hole cap is not
leaked or broken.
3. Fill water tank with tap water full to capacity, wait for 5 minutes until
water settles.
4. Press the hot water faucet button until water comes out, then stop.
OUT
OUT
OR
OR
SERVICE
SERVICE
OUT OR
OR SERVICE
SERVICE
FIRST
FIRST
OPERATION
OPERATION
FIRST OPERATION
OPERATION
Advertisement
