Eng; Operation Of The Amplifier; Specifications - Crunch GTO1200 User Manual

Please read the user's manual carefully before the installation and the first

operation of the amplifier.

SPECIFICATIONS

Output Power RMS
Output Power Max.
Loudspeaker impedance
Frequency Response
Total Harmonic Distortion
Signal-to-Noise Ratio
Input Sensitivity
Input Impedance
Lowpass Filter
Subsonic Filter
Bass Boost
Phase Shift
Operating Voltage
Fuse Rating
Dimensions (B x H x L)
All Specifications are subject to change
1-OHM OPERATION
If you want to run the amplifier in 1-Ohm operation, sufficient cooling should be provided at the installation point. An installation
point in confined spaces or storage compartments must be discouraged, otherwise, the amplifier could overheat and be damaged
permanently. If the fuses burn through during the 1-Ohm operation, replace them by 2 x 30 A fuses (but only for 1-Ohm operation).
WARRANTY
This product meets the current EU minimum warranty requirements, if purchased in countries of the EU. To ensure your warranty
policy keep your original receipt proofing the date of purchase. Any damage to the product as a result of misuse, abuse, accident,
incorrect wiring, improper installation, alteration of date code or barcode labels, revolution, natural disaster, or any sneaky stuff
because someone messed up, repair or alteration out side of our factory or authorized service centers and any thing else you
have done that you should not have done is not covered. This warranty is limited to defective parts and specifically excludes
any incidental or consequential damages connected therewith.

ENG

GTO1200
1 x 300 W @ 4 Ohms
1 x 450 W @ 2 Ohms
1 x 600 W @ 1 Ohms
1 x 600 W @ 4 Ohms
1 x 900 W @ 2 Ohms
1 x 1200 W @ 1 Ohms
1 – 8 Ohms
10 – 250 Hz (-3 dB)
< 0,2 % (100 Hz)
> 85 dB
6 – 0,2 V
RCA 20 kOhms, High Level 2,2 kOhms
50 – 250 Hz @ 12 dB/Octave
10 – 50 Hz @ 12 dB/Octave
0 – 12 dB @ 45 Hz
0 - 180°
+12 V (12 – 16 V), negative ground
2 x 25 A
135 x 50 x 210 mm
8