Swisher LS12534H Shown Owner's Manual page 17

Hide thumbs Also See for LS12534H Shown:
Table of Contents

Advertisement

Problem
Leaking Cylinder
Engine will not turn over
Engine clicks but will
not start
Battery will not charge
NOTE: For repairs beyond those listed here, contact your nearest authorized service center.
* Flushing the reservoir tank and hoses with kerosene whenever service is performed on the tank, hydraulic pump or
valve is recommended. Contact an authorized service center.
Date of Service
TROUBLESHOOTING CONTINUED
Cause
1. Broken seals.
2. Scored cylinder.
12 Volt Units
1. Weak or dead battery.
2. Blown fuse.
3. Corroded battery terminals.
4. Loose or damaged wiring.
5. Faulty ignition switch.
6. Faulty solenoid.
1. Weak or dead battery.
2. Corroded battery terminals.
3. Loose or damaged wiring.
4. Faulty solenoid.
1. Bad battery.
2. Corroded battery terminals.
3. Faulty solenoid.
4. Bad alternator.
MAINTENANCE LOG
Service Performed
1. See authorized service center.
2. See authorized service center.
1. Recharge or replace battery.
2. Replace fuse.
3. Clean battery terminals.
4. Check all wiring.
5. Check/replace ignition switch.
6. Check/replace solenoid
1. Recharge or replace battery.
2. Clean battery terminals.
3. Check all wiring.
4. Check/replace solenoid.
1. Replace battery.
2. Clean battery terminals.
3. Check/replace solenoid.
4. See authorized service center.
17
Remedy
Notes

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents