Download Print this page

Black & Decker VEC1045BD User Manual

Vehicle power system power inverter 200/400/750 watt
Hide thumbs

Advertisement

VEC1045_46_47_BD_Manual
4/28/05
Fault Protection Code and Troubleshooting Guide
INVERTER POWER SWITCH TURNED ON
Trouble/Indication
Possible Cause
No AC output —
DC input is out of range
(red LED lit
Excessive load —
thermal shutdown
No AC output —
Fuse(s) open
green LED not lit
Low battery alarm
Low battery voltage
sounds continuously
Bad connection or wiring
Motorized power tool
Excessive start-up load
will not start
Motorized power tool
Purely inductive load
does not operate at
correct speed
Television/Radio
Snow in picture,
interference
"buzzing" sound
SPECIFICATIONS
Power Inverter Model
VEC1045BD
Maximum Continuous Power:
200 watts
Surge Capacity:
400 watts
Input Voltage:
Output Voltage:
Low Voltage Alarm:
Low Voltage Shutdown:
Thermal Shutdown:
Wave Form:
Output Connection:
Input Fuses:
Input Cables:
Additional Protection:
5:16 PM
Page 8
Suggested Remedy
Check battery voltage.
Turn unit off. Reduce the load,
wait for the inverter to cool
down, then turn the unit on
again.
Check DC input — fuse(s) in
vehicle. Replace the fuse with
one of the same type and rating
if necessary.
Recharge battery. Remove
load from the inverter while
recharging battery.
Tighten all DC connections.
If appliance does not start,
appliance is drawing
excessive voltage and
will not work with inverter.
Make the load not purely
inductive. Operate an
incandescent lamp at the
same time as motor.
Keep inverter and antenna
distant from each other. Use
shielded antenna. Connect
antenna to amplifier.
VEC1046BD
VEC1047BD
400 watts
750 watts
800 watts
1500 watts
12.8 volts
Approx. 115 volt AC RMS 60 Hz
11 volts DC ± 0.3 volt DC
10.5 volts DC ± 0.3 volt DC
Automatic
Modified Sine Wave (MSW)
North American Standard Receptacles
Internal
Battery cable with ring connector
Overload, over voltage, overheating
8
VEHICLE POWER SYSTEM
POWER INVERTER
200/400/750 WATT
USER'S MANUAL
& WARRANTY INFORMATION
I I I I M M M M P P P P O O O O R R R R T T T T A A A A N N N N T T T T S S S S A A A A F F F F E E E E T T T T Y Y Y Y I I I I N N N N F F F F O O O O R R R R M M M M A A A A T T T T I I I I O O O O N N N N , , , , S S S S A A A A V V V V E E E E T T T T H H H H E E E E S S S S E E E E I I I I N N N N S S S S T T T T R R R R U U U U C C C C T T T T I I I I O O O O N N N N S S S S
TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND
THIS INSTRUCTIONAL MANUAL. THIS MANUAL CONTAINS IMPORTANT
INFORMATION REGARDING THE OPERATION AND WARRANTY OF THIS
PRODUCT. PLEASE RETAIN FOR FUTURE REFERENCE.
4140 S.W. 30th Ave., Ft. Lauderdale, FL 33312
Toll Free: (800) 618-5178
www.vectormfg.com
VEC1045BD / VEC1046BD / VEC1047BD

Advertisement

loading

  Related Manuals for Black & Decker VEC1045BD

  Summary of Contents for Black & Decker VEC1045BD

  • Page 1: Warranty Information

    VEC1045_46_47_BD_Manual 4/28/05 5:16 PM Page 8 Fault Protection Code and Troubleshooting Guide VEC1045BD / VEC1046BD / VEC1047BD INVERTER POWER SWITCH TURNED ON Trouble/Indication Possible Cause Suggested Remedy No AC output — DC input is out of range Check battery voltage.
  • Page 2: Important Safety Instructions

    VEC1045_46_47_BD_Manual 4/28/05 5:16 PM Page ii IMPORTANT SAFETY INSTRUCTIONS Important Cable Information Substantial power loss and reduced battery operating time results from inverters installed with cables that To ensure reliable service, your power inverter must be installed and used properly. Please read the are not able to supply full power.
  • Page 3: Table Of Contents

    The VEC1045BD features one outlet; the VEC1046BD and VEC1047BD feature two. The outlets can accommodate either two- or three-pin AC plugs. Power may also be supplied through the 12 volt DC outlet on the VEC1045BD (only). ATTN.: CUSTOMER SERVICE 4140 SW 30th Ave., Ft.
  • Page 4: How This Inverter Works

    VEC1045_46_47_BD_Manual 4/28/05 5:16 PM Page 2 The modified sine wave produced by the Power Inverter has an RMS (root mean Figure 2. VEC1046BD/1047BD Front Panel 4 4 4 4 3 3 3 3 square) voltage of 115 volts, which is the same as standard household power. Most 1.
  • Page 5: Run Times

    VEC1045_46_47_BD_Manual 4/28/05 5:16 PM Page 4 Short Circuit Protection — Notes: Reverse polarity or short circuit condition may cause Most vehicle accessory outlet circuits have fuses rated at 15 to 20 amps or greater. To operate at full wattage, either use the battery clip cable (supplied) external or internal fuses to open and may cause irreversible damage to the Power or directly wire to the power source with user-supplied wire and fuse.
  • Page 6: Connection To Load

    VEC1045_46_47_BD_Manual 4/28/05 5:16 PM Page 6 This problem does not occur with most battery-operated equipment. 9. Test the inverter by turning it on and plugging in a 100 watt lamp or equipment. Most of these devices use a separate charger or transformer that is 10.

This manual is also suitable for:

Vec1046bdVec1047bd