Rockford Fosgate PA2 Manual page 8

12. RCA Input/Output Jacks – The industry standard RCA jacks provide
easy connection for low level preamp signals. They are gold-plated to
resist the signal degradation caused by corrosion.
13. Input "A" – These L & R inputs feed the preamplifier when the front panel
A/B input switch is set to input "A."
14. Input "B" – These L & R inputs feed the preamplifier when the front panel
A/B input switch is set to input "B."
15. Front Output – These full range (20Hz to 20kHz) fadable stereo outputs
connect to the amplifier driving the "front stage" speaker system.
16. Rear Output – These full range (20Hz to 20kHz) fadable stereo outputs
connect to the amplifier driving the "rear stage" speaker system.
17. Subwoofer Output – These full range (20Hz to 20kHz) fadable stereo
outputs connect to the amplifier driving the "subwoofer" speaker system.
Technical Note: Creative installations can use the subwoofer outputs as
a full range center channel with dedicated volume control. Just
remember to keep the subwoofer boost/cut control to its flat (center)
position and always think "center channel."
18. Power Connector – The power connector provides a convenient
connection for ground, power and remote. The connector uses "screw
lock" terminals to secure the power wires and is removable for quick
disconnects.
19. Input "A" Gain Control – The input gain control is factory preset to
match the output of most source units. It can be adjusted to match the
source unit to tape/VCR audio/video game audio inputs.
20. Clipping LED Trim Pot – This potentiometer controls the threshold of the
signal strength/clipping LED. It can be set to illuminate the LED when
clipping occurs (0dB gain overlap) or when the desired amount of gain
overlap (+5dB, +10dB, +15dB) is reached.
21. Red/Green Illumination Switch – Selects the backlighting color to red
or green.
22. B+ Fuse – The internal B+ fuse protects the power supply and battery
from short circuits and power failures.
– 4 –