Recalling A Memory Channel; Deleting A Memory Channel; Programming A Repeater-Access Function Setting - Alinco DJ-175 T Instruction Manual

4.Basic Operation

4.5.2 Recalling a Memory Channel

1. Select the Memory mode by pressing the
appear on the display to indicate that the unit is in the Memory mode.
Repeat to switch between the Memory and VFO modes.
2. Select a memory channel.
Rotating the main dial will increase or decrease a memory channel number.

4.5.3 Deleting a Memory Channel

1. Select the Memory mode by pressing the
2. Rotate the dial to select the memory channel No. that you wish to delete.
3. Press the FUNC key, and while
4
beep sounds, then "
NOTE:
When "
on the display), it is still possible to cancel the operation by pressing the FUNC
key, and while
channels or modes, this is no longer possible.

4.5.4 Programming a Repeater-Access Function Setting

The "Repeater-Access" function is to set the desired shift and tone parameters to the
current operating frequency by just 2 key-touches.
Please set the parameters to be applied to the Repeater-Access function here.
1. Enter the Memory mode (by pressing the
2. Rotate the dial to select MrpALLFRQ.
3. Set the most commonly used Repeater-Access parameters by referring to "Repeater-
Access" (page 40). The parameters that can be programmed in this memory are
marked * in the chart 4.5.5 on the next page. By activating the Repeater-Access
function these settings are applied to the operating frequency regardless of the
VFO/Memory/CALL modes, by temporary replacing the current parameters.
4. After programming is completed, press the FUNC key then press the
while MrpALL is displayed to store the edited parameters.
5. Rotate the dial to operate in the Memory mode by selecting channels or press the
NOTE:
• You can not communicate in the
• The
convert this memory to other purposes.
26
" flashes on the display.
" is flashing in step 3 (when the memory contents are displayed as is
is displayed on the LCD, press the
key for VFO mode operation.
channel is skipped during scanning. You can not delete or
key. "
key.
is displayed on the LCD, press the
key if necessary).
channel.
" and channel number
key. A
key. After changing
key