Table of Contents
Advertisement
I
1
On the new handset, press and hold
Note: Do not release
2
Put the new handset in the charger.
3
When the text "Start phone replacement?" appears, release
Press "Yes" (left soft key).
The text "Follow the instructions. Each step can take several minutes." appears in the display.
Press "OK"(left soft key).
4, 5
When the text "Please insert old phone in charger" appears, replace the new handset with the
old handset. The handset can either be switched on or off.
Note: If the rack charger is used, the same charging slot has to be used for both handsets.
The handset will be restarted and after a few seconds, the text "Saving settings. Do not remove
phone from charger" appears. The charger LED changes to slow orange flashing.
IMPORTANT: If the old handset cannot communicate with the charger, put the new handset in
the charger to restore its settings (that is, the handset's IPDI). If this step is not performed, the
new handset must be sent for service. The old handset's settings might be transferred to the
new handset by using PDM. See the handset's Configuration Manual.
When the text "Please insert new phone in charger" appears, replace the old handset with the
6, 7
new handset. The text "Restoring settings" appears.
IMPORTANT: Do not remove the handset while the text "Restoring settings" appears.
8
When the text "Phone successfully replaced. Please remove phone to restart." appears in the
display, remove the handset from the charger. The handset is automatically restarted.
LED Indications during Easy Replacement
The following table shows the LED indications that are used for the 5603 and the charger during
the easy replacement procedure. See also "Troubleshooting" on page 40.
LED indication
Orange, flashing (1 000 ms on, 1 000 ms off) File transfer during Easy Replacement.
Orange, flashing (100 ms on, 800 ms off)
Red, flashing (100 ms on, 800 ms off)
Red, flashing (900 ms on, 100 ms off)
Related Documents
•
Mitel 5603 Wireless Handset Configuration Guide
•
Installation and Operation Manual, WSM for Mitel
•
Installation and Operation Guide, Portable Device Manager (PDM), Windows Version
until you are instructed to do so.
Description
"Change phone" indication during Easy Replacement.
Error indication during Easy Replacement. Put back old
portable in charger.
Error during Easy Replacement. Service required for
both portables.
Maintenance
.
47
Advertisement
Table of Contents
