Advertisement
OPERATING INSTRUCTIONS cont.
Motor Thermostat
IMPORTANT:
This unit is equipped
with a motor protective thermostat. If
for some reason the vacuum cleaner
should overheat, the thermostat will
automatically turn the unit off. Should
this occur:
• Push the On/Off button once.
• Disconnect the plug from the
power source.
• Check the source of overheating
problem. (i.e. clogged hose or
filter)
TROUBLE SHOOTING GUIDE
PROBLEM
POSSIBLE REASON
1.
Power cord not firmly plugged into
outlet.
VACUUM WILL
2.
No power in wall outlet.
NOT OPERATE
3.
Needs servicing.
4.
Thermostat has tripped.
1.
Dust cup is full.
VACUUM WILL
2.
Unit clogged.
NOT PICK-UP OR
3.
HEPA Filter needs cleaning or
SUCTION POWER
replacing.
IS WEAK
4.
Debris screen needs cleaning.
1.
Dust cup is full.
TURBO BRUSH
2.
Rotating brush or elbow is
DOES NOT
obstructed.
ROTATE OR
3.
Belt is broken.
ROTATES
4.
Hose obstructed.
SLOWLY
5.
Debris screen is clogged.
DUST ESCAPING
1.
Dust cup is full.
FROM VACUUM
2.
Dust Cup is not installed correctly.
VACUUM, HOSE
1.
Hose clogged.
OR BRUSHES
2.
Dust cup is full.
WILL NOT PICK-UP
• If clogged hose or filter is found,
unclog the hose and replace the
filters.
• Wait at least 45 minutes before
attempting to reuse the vacuum.
• After unit has cooled down for
45 minutes, plug in the cleaner
and push the On/Off button. The
vacuum should start again.
• If the vacuum still does not start,
contact EURO-PRO Operating
LLC customer service at
1-800-798-7398.
POSSIBLE SOLUTION
1.
Plug unit in firmly.
2.
Check fuse or breaker. Replace
fuse/reset breaker.
3.
Call 1-800-798-7398.
4.
Turn the unit off and unplug from
outlet. Allow unit to cool down,
then restart.
1.
Empty and clean dust cup.
2.
Turn unit off and unplug from
wall outlet. Remove Dust Cup
Filter and check for object(s) in
air duct and remove.
3.
Clean or replace HEPA Filter.
4.
Clean debris screen.
1.
Empty dust cup.
2.
Clear obstructions.
3.
Call 1-800-798-7398.
4.
Clear obstruction.
5.
Clean debris screen.
1.
Empty and clean dust cup.
2.
Review Dust Cup instructions.
1.
Remove hose and/or brushes.
Remove obstruction from hose
and /or brush.
2.
Empty and clean dust cup.
9
GETTING TO KNOW YOUR TRANSFORMER VAC
22
Technical Specifications
Voltage:
120V., 60Hz.
Power:
10 Amps
1.
Hand Grip
2.
Telescopic Tube
3.
Locking Button
4.
Flexible Hose
5.
Dust Cup Release Button 1
6.
Dust Cup Handle
7.
Dust Cup (Container)
8.
Main Unit
9.
Intelli-Sense
TM
Filter
Monitor
10. Exhaust Filter Cover
11. On/Off Switch
12. Power Cord
13. Floor Brush Release Button
14. Floor Brush
15. Crevice Tool
16. Dusting Brush
17. Telescopic Tube Release
Button
18. Dust Cup Release Button 2
19. Cord Hook Release
20. Hose Connector
21. Shoulder Strap (not shown)
22. Air Driven Turbo Brush
2
Advertisement
