Remote Control Setting - Philips DTR4610 User Manaul

Assuming the settings of your receiver and recorder (refer to your VCR or DVD recorder user
manual) are done, to perform a recording you shall:
- Program a timer with your receiver (refer to section 6.3)
- Put your recorder in the appropriate status to be controlled by your receiver (refer to the VCR
or DVD recorder user manual).
At timer occurrence your recorder shall start and stop recording automatically.
Note: While the recording is in progress, your receiver is protected from inadvertent action to disrupt
the recording. To cancel the running recording, press E E X X I I T T . This brings up a small window prompting
you for confirmation. To cancel the recording, press O O K K .
System Settings Screen
20 A DVA N C E D S E T T I N G S

7.2 Remote control setting

If you have other items of equipment in your home and
the Philips remote control of your digital receiver
interferes with them, you can change the setting of your
remote control. Please note that you must change the
setting of both your remote control and receiver.
Changing the setting of your receiver
By default, your receiver is identified as Device 1 and the
remote control is set to control Device 1.
To change this identifier to Device 2:
- Select Installation, then Settings, and then System
Settings. The System Settings screen appears.
- Set Device to Device 2.
- Press OK to confirm and exit.
Changing the setting of your remote control
- Press number keys 1 and 3 simultaneously and hold
them for at least 4 seconds.
- Release these two keys.
- Enter the new code setting within the next 60 seconds:
• Either 2 for Device 2 (alternative setting).
• Or 1 for Device 1 (default setting).
Alternatively you may reset your remote control to its
default setting (Device 1) by removing the batteries.
At battery change, the remote control setting is reset to
Device 1. Please remember that if your remote control
was set so as to control Device 2, you must set it to
Device 2 again after changing the batteries.