Table of Contents
Advertisement
Electrical connection
Before you plug the appliance into the wall socket, make sure that :
• The supply voltage of the domestic wiring system
does not fluctuate by more than 10% plus or minus
from the value shown on the rating plate.
• The meter, the fuses, the supply line and the wall
socket are all suitable to carry the maximum load
required by the washing machine (2,2 kW).
The existing safety rules call for the appliance to be
connected to an efficient ground wire.
The manufacturer disclaims any liability whatsoever
if this accident prevention rule is not complied with.
This appliance complies with E.E.C. directive n° 87-
308 of 06.1987 relative to radio interference suppres-
sion and with E.E.C. directive n° 73-23 relative to
electrical safety.
Water connection
• The end of the water inlet hose must be connected to a cold water tap having 3/4" gas
thread spout or to a water tap having a quick-coupling connector after having introduced
in the hose ring nut a rubber sealing washer also provided with the machine.
• The curved end of the outlet hose should be inserted into a drain pipe not less than 70 cm
and not more than 1,0 m from floor level.
Make sure that the drain hose is always safely secured so that it will not become loose or fall
down from its position.
The water should drain freely and consequently, the drain hose should not be chocked or
placed in such a way as to obstruct the normal water flow.
If an extension is required, remember that it might cause a malfunction in the drain pump,
particularly if the extension has a length in excess of 1 meter or if the diameter of the extension
is smaller than the diameter of the original drain hose.
Water pressure :
Levelling
Cleaning the drain filter
Fig. 1
- open the flapdoor covering the filter by pressing the left hand side of the filter door
(fig. 1 & 2). Place a container underneath to catch any spillage. According to the models,
complete the draining of the appliance by taking away the yellow cap and by extracting
the little hose located on the left of the filter (fig. 3).
- turn the filter anticlockwise and clean it thoroughly with running water.
- refit the filter in the guides and turn it clockwise.
- refit the little hose and the yellow cap, then close the flapdoor.
Subject to technical alterations.
minimum : 5 N/cm
Fig. 2
The replacing of the power cord must
only be realized by the After Sales
Service.
2
2
(0,5 kg/cm
) - maximum : 80 N/cm
Level the appliance by screwing or by unscrewing
the adjustable feet.
Accurate levelling reduces vibrations, noises and
displacement of the washing machine during
operation.
After levelling, block the adjustable feet by
tightening the collars manually or with a screwdriver.
Clean regularly the filter located at
the front bottom behind a small
flapdoor. If you wash laundry with
a lot of fluffs, clean it at each wash.
Pull down the drain hose above a
receptacle put on the floor in order
to empty completely the washing
Fig. 3
machine, then :
2
2
(8 kg/cm
)
Hide quick links:
Advertisement
Table of Contents
