Drying Only; Automatic Washing And Drying - Zanussi ZKF 220 User Manual

132900571.qxd 11/05/2004 10:55

Drying only

Warning! Do not exceed the maximum laundry
loads:
- 2.5 kg (ZKF 220) or 3 kg (ZKF 221) for linen and
cottons
- 2.0 kg for synthetics.
The water tap must be open and the drain hose must
be positioned in the sink or connected to the drain
pipe.
1. Load the laundry
2. Select the (drying) for cottons (red sector) or
synthetics (black sector).
3. If you want a timed drying, depress TIME DRY
button until the time you want appears on the
display or depress the AUTOMATIC DRY button
until the pilot light corresponding to the degree of
dryness required illuminates.
4. Press the START/PAUSE button to start the
programme.
5. At the end of the cycle, turn the programme
selector to position O to switch the appliance off.
6. Remove the laundry.
Pagina 22
22

Automatic washing and drying

(NON-STOP programme)
Warning! For NON-STOP programmes, it is also
essential not to exceed the maximum load sizes of
2.5 kg (ZKF 220) or 3 kg (ZKF 221)for cotton and 2
kg for synthetics.
Do not use a dosing device/ball when carrying
out a washing & drying programme.
1. Load the laundry.
2. Add detergent and additive.
3. Turn the programme selector to the desired
programme.
4. Select eventually the required options by means
of the relevant buttons. If possible, do not select a
spin speed lower than that proposed by the
appliance to avoid a too long drying time so
saving energy.
In any case the reduction of the spin speed is
only possible after selecting drying. The lowest
values you can select are the following:
- 900 r.p.m. for cottons and synthetics with
electronic drying
- 900 r.p.m. for cottons and 700 r.p.m. for
synthetics with timed drying
5. Select the drying time or degree of drying.
6. Start the programme by depressing the
START/PAUSE button.
7. At the end of the programme, turn the programme
selector to the position O to switch the machine
off.
8. Remove the laundry.