Installing The Pipe Mount - Bosch AutoDome Instruction Manual

AutoDome Easy Mount
2.2

Installing the Pipe Mount

1.
2.
3.
4.
5.
6.
7.
NOTICE! The fasteners and mounting surface must be capable of supporting a maximum load
i
of 11.33 Kg (25 pounds).
Fig. 2.5 Attaching the pendant pipe mount to the ceiling
CAUTION! Select a rigid mounting location to prevent excessive vibration to the AutoDome
!
Easy Camera.
Bosch Security Systems
Determine a secure location for the Pipe Mount.
Use the four holes in the flange as a template to mark the position where the holes
should be drilled to secure the mount.
Drill the four holes in the mount location (not supplied, use a minimum of 10 mm
(.39 in.)).
Drill a fifth hole (maximum of 20 mm) in the center of the four-hole pattern used to
mount the flange. Use this hole to feed the wires through the mount.
Assemble flange to the pipe and the pipe to the cap.
Note: Select the pipe length of 20 cm (7.9 in.), 30 cm (11.8 in.), or combine the two pipes
with the supplied coupler for 50.5 cm (20 in.).
Pull the wires through the pipe starting at the flange end.
Attach the mount to the ceiling with the appropriate hardware (not supplied).
Instruction Manual
Installation | en 5
F01U064856 | 1.0 | 2007.03