Table of Contents
Advertisement
INSTALLATION: "REGULATING THE FLAME"
• SETTING THE IDLE FLAME
If you have changed the type of gas, it is important to verify the flame stability at the
minimum regulation.
"Gaining access to the by-pass screw"
To gain access to hob burner by-pass screws, remove the knobs from the control panel.
!
Never loosen
the others screws !
REGULATING THE MINIMUM FLAME ON THE HOB BURNER
a) Natural gas :
. simply loosen the screw.
. switch on the burner and turn
. Turn the by-pass screw
minimum to maximum position to check that it is satisfactory.
b) Butane-propane gas :
The by-pass screw should be screwed
12
12
12
12
12
"REGULATING THE FLAME"
"REGULATING THE FLAME"
"REGULATING THE FLAME"
"REGULATING THE FLAME"
By-pass screw of the hob burner
the knob to minimum.
until a low flame is visible. Turn the control knob from
fully home, without being locked.
Advertisement
Table of Contents
