Installation; Installation Procedure For Windows 98 Se - Belkin F5U222vuk1 User Manual

Installation Procedure for Windows 98 SE

This installation procedure will install two USB 1.1 OHCI controllers, one USB
2.0 EHCI host controller, and the associated USB root hubs.
Note: Do not insert the Notebook Card into your computer until instructed to
do so.
1. Insert the F5U222 installation CD into your CD-ROM drive. After a few
2. Select "Install USB 2.0 Driver".
3. The setup utility will now install a CardBus eject utility for your USB 2.0
4. After the driver is installed, select "Yes, I want to restart my computer
5. After Windows restarts, locate your laptop computer's CardBus slot.
6. Insert the Notebook Card into the slot. Apply pressure as needed until it is
7. After inserting the Notebook Card, Windows will detect the "NEC USB Open
8. Select "Search for the best driver for your device (Recommended)" and
9. Uncheck all the boxes and click "Next". Windows will locate the drivers for
5242uk_F5U222vuk1.indd 5
moments, the main menu should automatically appear.
CardBus adapter. Make note of the information provided regarding the eject
utility, then click "Next" to continue.
now." Click "Close".
fully seated.
Host Controller" and the "Add New Hardware Wizard" dialog box will open.
Click "Next".
click "Next".
"NEC USB Open Host Controller". Click "Next". (At this point Windows may
prompt you to insert your Windows installation CD. If so, insert the CD into
the CD-ROM drive and continue the installation procedure.)

Installation

13/7/06 3:54:22 pm
EN
5