Operating System Compatibilit; Installation Procedure For Windows 98 Se Os; Installation - Belkin F5U219 User Manual

Installation

Please refer to the section that corresponds to your version of the Windows
operating system (OS).

Installation Procedure for Windows 98 SE OS

This installation procedure will successfully install two USB 1.1 host
controllers and a single USB 2.0 enhanced host controller.
1. Ensure that your computer is powered down.
EN
2. Locate an available PCI slot on your computer.
3. Insert the PCI Card into the slot. Apply enough pressure to ensure that it
is fully seated.
4. Insert the Belkin USB 2.0 driver installation CD into your computer's CD-
ROM drive.
5. Turn on power and boot-up the computer.
6. The Windows OS will recognize the PCI Card as a "NEC USB Open Host
Controller" and the "Add New Hardware Wizard" dialog box will open.
Click "Next".
7. Select "Search for the best driver for your device" and click "Next".
8. Uncheck all the boxes and click "Next".
9. The Windows OS will find the drivers for "NEC USB Open Host Controller".
Click "Next".
10. The Windows OS may ask you for the Windows OS installation CD.
If prompted to, insert the CD into the CD-ROM drive and follow the
subsequent instructions.
11. After the Windows OS installs the required drivers, installation of the first
host controller is complete. Click "Finish".
12. The "Add New Hardware" wizard will repeat the installation process for
the second OHCI host controller.
13. Repeat steps 7-11.
14. After installation of the two OHCI host controllers, the Windows OS
will detect "PCI Universal Serial Bus". This is the USB 2.0 EHCI host
controller.
15. The "Add New Hardware Wizard" dialog box will open. Click "Next".
16. Select "Search for the best driver for your device" and click "Next".
4 4