Any electrical work required to install this appliance
should be carried out by a qualified electrician or
competent person, in accordance with the current
THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should these
safety measures not be observed.
This appliance is designed to be connected to a
230 V 50 Hz AC electrical supply.
Before the appliance is connected:
1) check that the main fuse and the domestic installation
can support the load (see the rating label);
2) check that the power supply is properly earthed in
compliance with the current rules;
3) check the socket or the double pole switch used for
the electrical connection can be easily reached with
the appliance built in the forniture unit. Before
switching on, make sure the electricity supply voltage
is the same as that indicated on the appliance rating
plate. The rating plate is located on the bottom of the
hob. A copy is attached on the back cover of this
The appliance is supplied with a 3 core flexible supply
cord incorporating a plug. Connect the plug to an adequate
In the case of a permanent connection, it is necessary
that you install a double pole switch between the
appliance and the electricity supply (mains), with a
minimum gap of 3 mm between the switch contacts and
of a type suitable for the required load in compliance
with the current electric regulations.
The switch must not break the yellow and green earth
cable at any point.
Ensure that the hob supply cord does not come
into contact with surfaces with temperatures
higher than 50 deg. C.