Table of Contents
Advertisement
Technical Data
Gas Burners Rating
Rapid Burner
Auxiliary Burner
Semi-rapid Burner
Appliance Class
Appliance Category
Appliance Gas Supply
Gas connection
Electric Supply
Characteristics of Burners, Nozzles and Taps
Burner
Auxiliary
Semi-rapid
Rapid
(*) 1 mbar = 10 mm. water column
Instruction for the Installer
This hob must be installed by qualified personnel.
The manufacturer will not accept liability, should
the above instructions or any of the other safety
instructions incorporated in this book be ignored.
Gas Connection
On the end of the shaft (A), which includes the GJ 1/2"
threaded elbow, an adjustable joint is fixed so that the
washer (B) is fitted between the components as shown
in the diagram (Fig. 4).
A drop of paint at both edges of the "L" joint (C) will
evidence that the good seal of the connection has been
tested in the factory.
Before connecting the gas supply pipe to the joint (C),
the installer will ensure that the paint drop is unbroken
and the "L" connector has not been removed by the
vibrations during handling and transportation.
When the final connection has been made, it is essential
that a thorough leak test is carried out on the hob and
installation.
Ensure that the main connection pipe does not exert
any strain on the hob.
8
2.45 kW
0.95 kW
1.60 kW
LPG 30 mbar
RC 1/2 inch (1/2 inch male)
230 V 50 Hz
Nominal Power LPG (Butane"A")
kW
kCal/h
0.95
814
1.60
1368
2.45
2095
Overall dimensions
Width
Depth
Hob recess dimensions
Length
3
Width
I3
Diameter
Tap. By-Pass
Nozzle
g/h
50
75
65
126
80
193
Fig. 4
Feeding
Pressure
mbar (*)
28
35
30
45
FO 1010
A) End of shaft with nut
B) Washer
C) Adjustable joint
750 mm
510 mm
560 mm
480 mm
Advertisement
Table of Contents
