Care And Cleaning (Dx937Cx-Dh93K-Dh93Cx) - Hotpoint DH93 X Instructions For Installation And Use Manual

Care and Cleaning
(DH93K-DH93CX)
GB
Take particular care not to damage the inner
surface of the door inner glass that is coated with
a heat reflective layer. Do not use scouring pads,
or abrasive powder, which will scratch the glass.
Ensure that the glass panel is not subjected to
any sharp mechanical blows.
Stubborn stains can be removed by using a fine
steel wool pad. For slight soiling the inner glass
panel may be cleaned, while still warm, without
removing it from the door. After cleaning, rinse and
dry with a soft cloth.
CLEANING THE DOORS
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop
down doors, except take care to support the
weight of the inner glass when removing and
refitting.
DROP DOWN DOORS
Remove the door inner glass as follows.
1. Open the door fully and unscrew the two screws
securing the glass panel
so that the securing
brackets can be turned.
There is no need to
remove the screws
completely.
2. Turn the brackets so that the glass can be removed
and cleaned at the sink (Fig. 1.).
3. The inside of the outer door glass can now be
cleaned while still fitted to the cooker.
NEVER OPERATE THE COOKER
WITHOUT THE INNER DOOR GLASS IN
POSITION.
Refit the door inner glass as follows.
1. NOTE: The inner door glass has a special reflective
coating on one side.
Replace the door inner
glass so that the
s t a t e m e n t :
"IMPORTANT THIS
FACE TOWARDS THE
OVEN" can be read from the inner side of the door.
2. Turn the two securing brackets back to their original
position to retain the glass and tighten the screws
(Fig. 2.)
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
34
DROP DOWN DOORS -DX937CX
Remove the door inner glass as follows.
Remove screws from both side of door
Gently ease the top trim away from door
Gently ease glass upwards and remove from door
NEVER OPERATE THE COOKER WITHOUT THE
INNER DOOR GLASS IN POSITION.
Refit the door inner glass as follows.
1. Open the door fully.
2. Locate the inner door glass into its slots. The
inner door glass has a special reflective coating
on one side, in order to minimise surface
temperatures and energy consumption during
use, it is important it is fitted correctly.
3. Carefully slide the glass into its slots as far as it
will go and replace the top filler cap.
GB