Enable/Disable Functions - Garmin MX20 Installation Manual

Multi-function display

Hide thumbs Also See for MX20:

Table of Contents

Installation

4. Select the INSTL function by pressing the smart key directly below the INSTL label. The

Enable/Disable Functions will be the first screen to appear.

MX20 power must be cycled before configuration changes will take affect.

After a configuration change, a message will appear on the screen telling you to wait 30

seconds before turning off power. You may continue to make configuration changes without

pausing; however, do not turn off power to the MX20 until waiting 30 seconds after the last

configuration/ setting change. The message will disappear when it is safe to cycle power.

2.7.1 Enable/Disable Functions

This menu allows the activation or deactivation of MX20 functions.

1. Ensure the Enable/Disable Functions page of the MX20 has the desired configuration.

Modifications can be made using the line select keys.

a. Enable Message to allow viewing of system messages.

b. Enable Custom Map to allow viewing of the Custom Map function.

c. Enable IFR En Route Map to allow viewing of the IFR Map function.

d. Enable VFR Sectional Map to allow viewing of the VFR Map function.

e. Enable the Split Screen function to allow viewing of two functions side by side.

2. Press the Next Page line select key to view additional functions.

a. Enable Traffic only if a traffic sensor is installed.

b. Enable FIS Data Link only if a UAT, GDL 69/69A, or WSI InFlight system is installed.

c. Enable XM Satellite Radio if a GDL 69A is installed. This should be disabled if a GDL 69 is

installed.

d. Enable Flight Plan to allow viewing of flight plan route lines on the display.

e. Enable Terrain only if an altitude encoder is installed, either directly or through a navigation

source, or if a TAWS sensor is installed.

NOTE

560-1025-09 Rev E

MX20 Installation Manual

Table of Contents