How To Use Controls Detergent And Additives; Loading The Washing Machine; Dose De Washing Powder; Dose The Additives - Zanussi ADVANTAGE400 Instruction Booklet

HOW TO USE THE CONTROLS DETERGENT AND ADDITIVES

1. LOADING THE WASHING MACHINE

Load the laundry loosely, alternating large items with small
ones.
Do not overload the washing machine, but always try to use
its utmost capacity in accordance with the type of fabric.
Reduce the quantity when washing very dirty or fluffy
laundry .
Once the machine is working and you wish to add any item
you must stop the program.
IMPORTANT REMARK: This appliance is provided with a
security device to avoid opening during the cycles. Open it
only when absolutely necessary and wait 2 to 3 minutes
after you have stopped the machine to give the safety
device time to unlock.
2. DOSE THE WASHING POWDER
AL025

3. DOSE THE ADDITIVES

AL023
Pull the handle to open the
dispenser. Enter the
advised quantity of washing
powder into
compartment .
For prewash use
compartment .
If you wish to use additives
enter the softener in the
compartment with the
symbol

4. SELECT THE TEMPERATURE

You can change the temperature of the programs stated
with 90°C pressing the «E» button, then the maximum
water temperature will be 60°C.

5. SELECT THE PROGRAM

Turn the dial clockwise until the marker reaches the desired
program.

6. START

The door is properly closed.
The appliance is plugged in.
The water supply tap is turned on.
The drain filter is tight.
The drain hose is adequately positioned.
Pull the program dial up to you till it klicks.
The pilot light comes on and the program will begin.

7. STOP

The washing machine stops automatically once the cycle is
finished, the pilot goes out. Open the door 2 to 3 minutes
after the end of the program to give the safety device
time to unlock.
Close the tap and unplug the appliance. Leave the door
ajar for a few minutes for the steam to get out.
7