Door Reversibility; Electrical Connection; Technical Specification - Zanussi ZFC202-1 Instruction Booklet

Door reversibility

Unplug the appliance before performing the
following operations:
Carefully lay the appliance on its back.
Remove the foot (A-Fig. 3).
Remove the hinge (C) by unscrewing the screws (B).
Remove the stop catch (E) by unscrewing the screws
(D).
Slide the door out of the upper hinge.
Remove the upper hinge and fit on the opposite side
(Fig. 4).
Reassemble the door, inserting the upper hinge pin
into the bushing on the door.
Unscrew the left foor and refit on the opposite side.
Fit the stop catch (E) on the opposite side.
Fit the hinge (C) and foot (A) on the opposite side.
Change the position of the handle (Fig. 5).
The holes that are not used are to be masked with the
plastic plugs removed.
Attention
After completion of the door reversibility operation,
verify that the door gasket is adherent to the cabinet.
If the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdrier.

Electrical connection

Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by 6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The technical data is indicated in the rating plate on the left side inside the appliance.
6
TECHNICAL SPECIFICATION
E
C
D
B
D473
D185
D162
Fig. 3
A
Fig. 4
Fig. 5
GB