Please fill in the necessary details on the Card Certificate and send it to the Zanussi Centre covering the area in which the appliance is to be installed. (See list of Zanussi network centres).
WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.
INSTALLATION If this refrigerator featuring magnetic door seals is to replace an older appliance having a spring lock on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child.
Changing the opening direction of the door Unplug the appliance before performing the following operations: Remove the ventilation grille (D-Fig. 4). Unscrew the bottom hinge (E-Fig. 4). Remove the screws of the bracket with foot (I) and levelling foot (H) and reassemble them on the opposite side (Fig.
Operation - Temperature adjustment Turn the thermostat knob clockwise beyond position «O» to the required setting. A medium setting is generally the most suitable. Temperature is adjusted automatically and may be increased (less cold) by turning the knob towards the lower numbers, or may be decreased (colder) by turning it towards the higher numbers.
Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required (Fig.
Defrosting While in operation, the refrigerated surfaces of the evaporator become progressively covered with frost. This frost, which acts as a thermal insulator and thus prevents the cold from reaching the food, should be removed at regular intervals, otherwise, there will be a marked rise of temperature in the compartment concerned and a wastefull increase in power consumption.
MAINTENANCE Before carrying out any maintenance operation, always disconnect the plug from the wall socket. Periodical cleaning Wash the interior of the appliance with lukewarm water and sodium bicarbonate. Clean cabinet outer surfaces with a silicone-wax spray. The condenser and compressor should be cleaned using a brush or a vacuum cleaner.
Need help?
Do you have a question about the ZFC 282 C and is the answer not in the manual?
Questions and answers