Removing And Installing Decorative Plugs - EdgeStar CWR531SZ Owner's Manual

Removing and Installing Decorative Plugs

Follow the instructions below to remove the decorative plugs from
the door.
IMPORTANT: Before you begin, unplug the refrigerator.
1. Open the door and carefully pull the door gasket from
the top left corner until you have exposed the two holes which
correspond with the decorative plugs. Note: A small Flathead
screwdriver is required.
2. Insert the Flathead screwdriver through the gasket side of the
door into the decorative plug slot. You may need to use a flashlight
to help guide you through this process.
3. Carefully turn the screwdriver clockwise to remove the two pre-
installed decorative plugs from the front of the door. Reinsert the
decorative plugs to the right side of the door using this same
procedure.
4. Remove the decorative plastic cap from the top left corner of the
door and insert it onto the right top corner.
5. After the cap is inserted carefully press the door gasket into its
original position.
EdgeStar Wine Refrigerator 8