Baxi 828 Installer And Owner Manual page 19

INSTALLER AND OWNER GUIDE
The light bulbs fitted to this heater are standard clear 40W max. E14 candle lamps, but
due to the indeterminate life span and ease of replacement, they are specifically
excluded from the guarantee.
To replace the light bulb(s).
1. To gain access to the light bulb/s, remove the
loose coals / pebbles from the fuel support and
place them onto an old newspaper or plastic
bag. This will prevent them from marking the
surface.
2. Remove the firefront, (On the Adage heater
it will be necessary to remove the whole
fascia), see figure 3 and the section headed
" Removing the fascia".
3. Unscrew and remove the copper reflector
plate (See figure 21).
Figure 21. Copper reflector
4. Replace the light bulb/s with clear
40 Watt (maximum) candle, Edison
screw, SES E14.
5. Refit the copper reflector plate. Refit
the firefront / fascia and coals /
pebbles.
2. My heater is on but there is no
light or heat.
The first thing to do is check the wall
socket. To do this plug in a known
working appliance. If the appliance
you have plugged in works then there
is a good chance that the problem lies
Figure 22. Bulb replacement
with the 13Amp fuse in the heater
plug. If either fuse or socket is suspected, have them checked by an electrician.
3. My heater is on but there is no heat.
A cut out device is fitted to the heater to prevent damage due to over heating. If it
operates due to an obstruction in the airflow, the heater must be turned off and allowed
to cool for 15 minutes and the obstruction removed before restarting.
©
Baxi Heating U.K. Limited 2006.
Page 18