Table of Contents
Advertisement
INSTALLER AND OWNER GUIDE
9. At the back of the heater there will be a
long piece and a short piece of wire
coming through the two holes. Hold the
short piece and give the long piece a
gentle tug. This will secure the steel wire.
Take the long piece and thread this
through the eyescrew in the back of the
fireplace opening (See figure 8 - item 4).
10. From the back of the heater thread the
long piece of steel wire through the outer
small hole on the right hand side of the
heater (See figure 8 - item 5).
11. Locate the heater in the fireplace
opening, then from the front of the heater,
gently pull the steel wire on the right hand
side to gather up the excess until the
heater is secure. Thread the wire through
the remaining small hole to lock the wire
and heater in place (See figure 8 - item 6).
Method C - Spacer Frame
The spacer frame is for use during
installations where a chimney recess or
rebated fire surround are not available.
For your safety the frame and heater must
be securely fixed to the rear wall.
Fitting the spacer frame
All models except Dream and Bolero.
(For Dream and Bolero see following section)
The rear of the spacer has two screw location
slots in the top flange. These should be to the
rear when fitting.
1. Position the spacer frame against the wall.
Ensure that the spacer frame is central to the
fireplace.
2. The top rear flange of the spacer frame has two screw locations. Mark the positions
of the two screw locations on the rear wall (See figure 9).
3. Remove the spacer frame from the fireplace and place away from the work area.
4. Drill the screw locations using a no. 12 masonry drill bit.
©
Baxi Heating U.K. Limited 2006.
Figure 8. Steel wire fixing (Detail at top of
heater may differ from that shown)
Figure 9. Location points
Page 11
Advertisement
Table of Contents
