Baxi 828 Installer And Owner Manual page 13

INSTALLER AND OWNER GUIDE
5. Insert two wall plugs provided into the holes.
6. Insert a 'C' screw into each hole and screw in until there is approximately 6mm of
screw protruding from the wall.
Bolero and Dream models.
The rear of the spacer has wider flanges. These should be to the rear when fitting.
1. Position the rear of the spacer frame against the wall. Ensure that the spacer frame is
central to the fireplace. It is important that the
side legs are positioned correctly and are
upright.
2. Mark the upper positions of the key hole
slots on the rear wall (See figure 10).
3. Remove the spacer frame from the fireplace
and place away from the work area.
4. Drill the screw locations using a no. 12
masonry drill bit.
5. Insert two wall plugs provided into the holes.
Figure 10. Location points
6. Insert a 'C' screw into each hole and screw
in until there is approximately 6mm of screw
protruding from the wall.
Preparing the heater for installation.
1. Ensure that the decorative front surround has been
removed from the heater as described earlier in this
guide.
Figure 11. Locating the cable
2. Using the four 'D' screws provided,
fix the heater to the spacer frame.
3. There is a supply cable slot on both
sides of the spacer frame. It is located
at the base. Decide which side to pass
the supply cable through and position
the supply cable in the spacer frame
slot (See figure 11).
Fitting the heater.
1. Locate the spacer frame and heater
over the screw heads ensuring a tight
fit. If the fit is loose, remove the spacer
Figure 12. Diffuser location
frame and heater from the wall.
Tighten the wall screws slightly and reposition the spacer frame and heater.
©
Baxi Heating U.K. Limited 2006.
Page 12