Zanussi ZDW 416 FS Instruction Booklet page 5

Fitting under a counter
(kitchen worktop or sink)
This dishwasher is designed to be fitted under a kitchen
counter or sink.
In either case, it is essential that the recess dimensions
indicated in the picture are followed.
No further openings for venting of the dishwasher are
required, but only to let the water fill and drain hoses
and power supply cable pass through.
II28
The recess height may be anywhere between 820
and 880 mm from the floor since the dishwasher
incorporates levelling feet adjustable over a wide
range (max 60 mm).
Adjust the height of the appliance by turning these
feet.
A distance of 2 mm should be allowed between the
top of the dishwasher and the counter top.
It is absolutely essential that the dishwasher is
disconnected from the electricity supply before gaining
access to any internal component.
Fit the dishwasher into the appropriate housing space
and connect it. Make sure that the water fill and drain
hoses and the power supply cable are not bent or
kinked.
Adjust the height of the plinth by following the instruc-
tions shown in the figure.
IN10
(ZDW 416 BU)
II06
Securing under a counter
Open the door; vertically insert the two mounting
brakets (A) on the front part of the dishwasher and
turn them 90° (see figure).
Secure the brakets to the counter by means of two
3,5 x 16 screws provided.
90
A
1
II18
Caution
Once the machine has been installed, ensure that it
can be accessed easily for servicing.
PIN23GB
5
(ZDW 416 BU)
A
2