Advertisement
Q7002A,B,C INTERFACE MODULES
Table 2. Acceptable Q7002C Inputs and
Dip Switch Settings.
PWM Time
B a s e
(in seconds)
Switch 3
0.1-2.65
Off
a
a
0.1-5.2
Off
0.1-12.85
Off
0.1-25.6
Off
0.59-2.93
On
a
Factory default setting.
INSTALLATION
When Installing this Product...
1. Read these instructions carefully. Failure to follow them
could damage the product or cause a hazardous
condition.
2. Check the ratings given in the instructions and on the
product to make sure the product is suitable for your
application.
3. Installer must be a trained, experienced service
technician.
4. After installation is complete, check out product
operation as provided in these instructions.
CAUTION
Electrical Shock or Equipment Damage Hazard.
Can shock individuals or short equipment
circuitry.
Disconnect power supply before installation.
CAUTION
Equipment Damage Hazard.
Electrostatic discharge can short equipment
circuitry.
Ensure that you are properly grounded before
handling a powered unit.
63-2551
Dip Switch Settings
Switch 4
Switch 5
Off
Off
a
a
Off
On
On
Off
On
On
Off
Off
Location
Select a location that meets the ambient temperature ratings.
NOTE: Installing the device inside a control panel can help
prevent damage.
Mounting
Enclosure
Mount the Q7002 Enclosure models in any position. The
enclosure models surface mount as follows:
1. Place the Q7002 in the desired location.
2. Attach the Q7002 to the mounting surface with two
standard metal screws.
NOTE: If desired, remove unused tabs by simply breaking
them off the housing. Once removed, they cannot be
replaced.
Snap-Track
The Q7002 Snap-track models surface mount as follows:
1. Remove the printed circuit board (PCB) from the snap-
track.
2. Attach the snap-track to the panel with standard metal
screws.
3. Place one edge of the PCB into the track and snap the
opposite edge into place.
Wiring
Wire the device using Fig. 2 through 7.
IMPORTANT
Comply with national and local codes when wiring
the device.
4
Advertisement
