Belkin F1DN102B User Manual page 14

InSTAllATIon InSTAllATIon
sections sections
table of contents table of contents
Step 3 Connecting Computers to the Switch
3 . 1 Make sure all computers are powered off.
3 .2 Using the Belkin DVI/USB KVM Cable Kit, connect the computers
to a port on the rear of the KVM Switch. (Refer to diagram on
page 8.)
note: The Cable Kit must be connected directly to a free USB port
on your computer with no USB hubs or other devices in between.
Refer to the Troubleshooting section of this manual if you are having
problems with the USB keyboard or mouse.
Secure DVI-I KVM Switch with Audio
1 1 2 2 3 3 3 3 4 4 5 5
Step 4 Powering up the Computers
Power up all the attached computers and check for display
and peripheral functionality. All computers can be powered on
simultaneously.
note: Your computers should recognize the Switch and automatically
install the HID USB driver if necessary.
When you power on your computers, the Switch emulates both a
mouse and keyboard on each port and allows your computers to
boot normally. The computer connected to port "1" will be displayed
on the monitor. Check to see that the keyboard, monitor, and mouse
are working normally. Proceed to do this with all occupied ports to
verify that all computers are connected and responding correctly.
If you encounter an error, check your cable connections for that
computer and reboot. If the problem persists, please refer to the
Troubleshooting section in this User Manual.
12
6 6 7 7 8 8