Pci Expansion Cards - Supero H8DGU-LN4F+ User Manual

H8DGU-LN4F+ Serverboard User's Manual
2-5

PCI Expansion Cards

A riser card is used to support one standard size (full height full length) PCI
expansion card.
Installing a PCI Expansion Card
1. Confi rm that you have the correct riser card for your chassis model and the
add-on card includes a standard bracket.
2. Remove the chassis cover.
3. Install the riser card by sliding card into the appropriate riser card in the
serverboard.
4. Choose the PCI slot shield in which to place the add-on card.
5. In that slot, open the PCI slot shield lever and slide the shield sideways.
6. From inside the chassis, remove the PCI slot shield.
7. Slide the add-on card into the riser card and attach the add-on card bracket
in place of the PCI slot shield.
8. Secure the add-on card by closing the PCI slot shield lever.
9. Connect cables to the add-on card as necessary.
Note: If the left side riser is with 2 or more x8 PCI-E slots make sure an installed
card on the left side riser is detected. If it is not, then go to the system's BIOS Setup
and in Advanced/ PCI/PnP Confi guration /SXB1 Confi guration BIOS setting select
the [2x8] option. Then save the BIOS setting changes and reboot the system.
2-8