Rotating The 90° Horn; Rotating The Logo - Electro-Voice Zx1-Sub Owner's Manual

Rotating the 90° Horn
The 90° version of the Zx1 allows for the horn to be rotated for more effective coverage if desired. The horn is factory-installed
with the 90° coverage in the horizontal plane and the 50° coverage in the vertical plane. The 100° version of the Zx1 has the
same coverage pattern in both the horizontal and vertical planes, so rotating the horn will not change the coverage pattern.
To rotate the horn follow the steps below:
1. Remove the grille screws/grille assembly.
2. Remove the horn screws/horn assembly.
3. Rotate the horn assembly 90°.
4. Secure the horn assembly with the horn mounting screws.
5. Secure the grille assembly with the grille mounting screws.
90° x 50°
Horn

Rotating the Logo

All versions of the Zx1 (except the Zx1-Sub) allow for the logo badge to be rotated, if
desired. The logo badge is square and can be rotated in 90° increments.
To rotate the logo badge, follow the steps below:
1. Using your finger or a flat-edge screwdriver (using care not to scratch grille),
grip/pry under the logo badge.
2. Pull the logo badge outwards from the logo recess until it fully clears the front
surface of the grille.
3. Rotate the logo badge, in 90° increments, to the desired orientation.
4. Release the logo badge and let it "spring" back into the logo recess.
Electro-Voice Zx1 Series Owner's Manual
90° x 50° Horn
Grille Mount
Screws
Figure 5:
Rotating the Zx1-90 Horn
Horn Mount
Screws
Grille
Assembly
Figure 6:
Rotating the Zx1 Logo
Enclosure
9