Table of Contents
Advertisement
Disposable Dust Bag and Filters
The disposable dust bag plays a very important role in the
efficiency of a vacuum cleaner.The purpose of the paper bag
is to trap dirt. As the bag traps dirt, it must also be porous
enough to allow air to pass on through. Change the dust
bag and check the filters frequently. Some fine particles can
restrict airflow very quickly and will decrease performance
even before the bag appears to be full.
When vacuuming carpet fresheners or cleaners, powder,
plaster dust, or similar fine substances, the bag and filters
may require more frequent maintenance.
NOTE: Service calls as a result of blocked/dirty filters
will be chargeable.
How To Change Dust Bags
NOTE: Turn off the switch and unplug the electrical
cord before changing dust bag. Never operate
the vacuum cleaner without the dust bag or the
filter.
NOTE: Style AA Filteraire bags must be used to
maintain HEPA grade filtration and prolong the
life of the HEPA filter.
NOTE: Models without HEPA filter option, may use Style
AA bags rather than Style AA Filteraire.
It may be more convenient to lower the handle to the floor
before changing the bag.
To Remove Bag:
A
Front
Cover
A. R e m ove f r o n t c ove r.
Grasp both sides of bag
cover near top. Push
thumbs against center
of cover and pull out on
sides.
To Replace New Bag:
C. Fold sides of paper bag below
bag collar.
D. Align bag collar hole and notch
with hose adapter.
E. Place bag collar corners on
ledges. Push collar to rear of
compartment. Check to be sure
hose adaptor inserts into bag
collar.
F. Tuck bag into bottom and along
sides.
G. Replace front cover. Make sure
disposable bag does not catch
under front cover.
B
B. Grasp bag collar; pull
down slightly and out
to remove bag.
E
D
Bag
Collar
C Bag
Side
Cyclonic Cassette
NOTE: Turn off the switch and unplug the electrical cord
before emptying cyclonic cassette or changing
the micron filter. Never operate the vacuum
cleaner without the cyclonic cassette or the filter
installed.
To Remove the Cyclonic Cassette:
Remove cyclonic cassette by
pushing up lever (1), unhooking (2)
by swinging outward from vacuum
body. When replacing cyclonic
cassette, hook at top where shown
(2), and swing back into place until
lever (1) snaps into place.
To change the Cassette Micron Filter:
1. Remove the filter frame by
grasping the handle on the
back of the filter frame and pull-
ing firmly. The filter frame will
drop down staying connected
at the hinges on the bottom.
2. Remove old filter and replace
with a new filter.
3. Reconnect filter frame to cas-
sette body by swinging filter
frame up and pushing against
cassette body until it snaps into
place.
Emptying the Cyclonic Cassette
It is clearly visible when the dust compartment is full and
needs emptying. Lift screen as shown (3) to completely empty
cyclonic cassette.
NOTE: The compartment with the screen (a) will fill much
faster with larger dirt particles than the compartment
with the cone (b). This is normal, empty the cyclonic
cassette when the side with the screen is full, do not
wait for the side with the cone to fill completely.
CAUTION: The cyclonic cassette can be washed in warm
water, but strong detergents should not be used.
E
Dry thoroughly before using again.
2
1
3
1. Filter Frame
2. Filter
3. Cassette Body
3
a
b
2
1
13
Advertisement
Table of Contents
