Electrolux Z1300 Series Owner's Manual page 6

Step C Store Hose and Accessories
Crevice
Tool
Extension
Wand or
Wands
HEPA Filter
(On some
models)
Tab
Hose
Retainer
Step E Store Electrical Cord
11
Cord
Cord
Retainer
Retainer
6
Combination
Tool
Hook
11
12
Cord
Hook
12
Cord
Hook
Step D Check Disposable Dust Bag
8. Remove front cover, grasp both sides of bag
9.
Carrying
Handle
10.
Or Check Cyclonic Cassette
Cassette Handle
Make sure that the cyclonic cassette is fully seated
in the vacuum. Place thumbs on cyclonic cassette
(marked by arrows above) and push firmly until it
clicks home.
NOTE: Do not lift cleaner by cassette handle,
11.
12.
NOTE: For easier access to bag compartment/
13.
8
10
cover near top. Push thumbs against center
of cover and pull out on sides.
9
Hose
Adapter
Check to be sure the paper bag collar is
secure with the hose adapter inside the paper
bag collar.
Replace front bag cover.
use carrying handle on the back of
cleaner. See illustration in Step C.
You will find your cord retainer either at the
bottom of the upper cord hook or on the
handle above the upper cord hook. Firmly
push the electrical cord down into either cord
retainer.This will place the cord out of the way
the next time you vacuum.
Next wind the cord around the two cord hooks
on the left side of cleaner. On some models
the upper cord hook turns to release the cord.
Turn the hook up to store the cord.
dust cup when you store the electrical
cord use a figure 8 pattern.
Secure the plug to the cord to prevent
unwinding.
Paper Bag
Collar