Yamaha FX High Output WaveRunner 2008 Owner's/Operator's Manual page 69

EJU32670
Switches
ECJ00410
CAUTION:
Do not run the engine for more than 15
seconds when checking the switches on
land without supplying water, otherwise
the engine could overheat.
Check the start switch, the engine stop
switch, and the engine shut-off switch for
proper operation.
Push the start switch to start the engine. As
soon as the engine starts running, push the
engine stop switch to verify that the engine
stops immediately. Restart the engine, and
then pull the engine shut-off cord to remove
the clip from the engine shut-off switch to ver-
ify that the engine stops immediately. (See
pages 31 to 32 for information on proper op-
eration of the start switch, the engine stop
switch, and the engine shut-off switch.)
1 Start switch
2 Engine stop switch
3 Engine shut-off switch
4 Clip
5 Engine shut-off cord
EJU32700
Cooling water pilot outlet
Check that water comes out from the port
(left) cooling water pilot outlet while the engine
is running and the watercraft is in the water.
(See page 32 for more information.)
EJU32710
Multifunction information center
Check the multifunction information center for
proper operation. (See page 39 for informa-
tion on proper operation of the multifunction
information center.)
Operation
64