Regular Cleaning; When The Refrigerator Is Not In Use; Trouble Shooting; How To Change The Bulb - Zanussi ZRB34ND Instruction Book

EN
Sweep off the melting water with a cloth or sponge in direction
of sides of the cooling plates. The melting water swept down
gathers in the outlet channel practically formed in the bottom
of the appliance and can be removed according to figure.
Put an adequately high bowl or dish under the outlet.
The bowl in figure is not a piece of accessories to the appli-
ance!
Wipe the surfaces after defrosting and leading the water out,
bend the plastic outlet back and fix it.
Put the mains plug into the mains socket and put foods taken
out back to their places.
It is recommended to operate the appliance at the highest
position of the thermostatic control for some hours so that it
can reach the sufficient storing temperature as soon as possi-
ble.

Regular cleaning

It is recommended to wash the inside of the refrigerator in 3-
4 weeks time using lukewarm water then wipe it (it is practi-
cal to clean the inside of the freezer and defrost it at a time).
Household cleaner or soap must not be used.
After breaking the circuit wash the appliance with lukewarm
water then wipe it. Clean the door gasket with clean water.
After cleaning apply voltage to the appliance.
It is recommended to remove the dust and dirt collected on
the back of the refrigerator and the condenser and to clean
the evaporative tray on top of the compressor once or twice
a year.
When the refrigerator
is not in use
In case the appliance will not be used for a long time fol-
low these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.
36

Trouble shooting

How to change the bulb

Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Press the rear hook (1) and at the same time slide the
cover in the direction indicated by the arrow (2). So the
bulb can be replaced. (Bulb type: T 25 230-240 V, 25 W,
E 14 thread)
After changing the bulb replace the cover, snap it in place
and apply voltage to the appliance.

If something does not work

During operation of the appliance some smaller but
annoying trouble can often occur, which does not require
calling a technician out. In the following chart information
is given about them to avoid unnecessary charges on
service.
We draw your attention that operation of appliance goes
with certain sounds (compressor- and circulating sound).
This is not trouble, this goes together with the operation of
the appliance.
We draw it to your attention again that the appli-
ance operates discontinuously, so the stopping of
compressor does not mean being no-current. That is why
you must not touch the electrical parts of the appliance
before breaking the circuit.