Installation; Location; Cleaning The Interior - Zanussi ZR 290/3TN Instruction Booklet

Table of Contents

Advertisement

If this appliance featuring magnetic door seals is to
replace an older appliance having a spring lock
(latch), be sure to make that spring lock unusable
before you discard the old appliance. This will
prevent it from becoming a death-trap for a child.

Location

Place the appliance away from all heat sources, such
as: radiators, heating stoves, direct sunlight, etc. Best
performance is obtained with ambient temperature
between +18 C and +43 C (class T); +18 C and
+38 C (class ST); +16 C and +32 C (class N); +10 C
and +32 C (class SN).
The class of your appliance is shown on its rating
plate.
For building-in instructions, see the relevant section.
16

INSTALLATION

It is essential that the appliance be connected to an
efficient earth tap. For this purpose the supply cable
plug incorporates a special earth contact. If the
sockets of your domestic wiring system are not
earthed, have the appliance connected to a separate
earth wire by a qualified electrician in accordance
with existing safety regulations.
The Manufacturer declines all responsibility if the
above safety precautions are not observed.
This appliance complies with EEC directive
number 87/308 of 2/6/87 relative to radio
interference suppression.
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.

Cleaning the interior

Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm
water and some neutral soap so as to remove the
typical smell of a brand-new product, then dry
thoroughly.
Do not use detergents or abrasive powders, as these
will damage the finish.
Important
This appliance complies with the following
E.E.C. Directives:
GB

Advertisement

Table of Contents
loading

Table of Contents